Fully insulated with Class ‘O’ open cell thermal and
acoustic foam.
Flush panel extra
rigid construction.
Low noise levels.
Eleven speed transformer.
Full acoustic and thermal
insulation.
Various filter options.
Outputs available up to
6.4kW cooling and 6.9kW heating.
|
|
| |
|
Actionair
Hydropac
Heavy Duty Air
Control and Shut-off Dampers PHW230 and PHW170
Series |
|
|
Actionair Hydropac horizontal ceiling void mounted
type fan coils are waterside control, suitable for operation
against moderate duct resistances, using chilled water cooling
medium and low pressure Temperature control is by means of
modulating 4 – port diverting valves on heating and cooling,
operated via stand alone or BMS temperature controller and
room or return air sensor. Designated ‘PHW’, the series
consists of standard 230mm deep and slimline 170mm deep
versions.
|
|
| |
|
Construction
Hydropac |
|
Catalogue |
|
|
Specification for
HYDROPAC
Chassis
Manufactured from 1.2mm
galvanised sheet steel with 1.6mm fan decks and back plates.
The chassis shall incorporate recessed, slotted mounting
points for drop-rods. An integral acoustically lined discharge
plenum fitted with spun steel spigots and insulated blanking
plates.
Access
Access to fans shall
be via an insulated bottom panel with keyhole
slots.
Insulation
100Kg/m3 density, class ‘O’ CFC and
HFC free open cell foam shall be utilised for both thermal
acoustic insulation.
Fans/Motors
Fan/motor shall be
permanent split capacitor external rotor ,forward curved
centrifugal type, with high efficiency, low noise multiblade
galvanised sheet steel impellers. Electrical supply shall be
230V 1ph 50Hz.
Speed Control
Speed
control shall be by means of a multi-tapped transformer giving
eleven settings. A panel mounted three speed switch with
additional Fine adjustment. On/off control to fans shall be by
means of a panel mounted illuminated two position
switch.
Coils
Coil matrix blocks
shall be copper with aluminium fins. Fitted with vents and
drains as standard
Condensate Tray
Condensate trays
shall be synthetically treated, galvanised sheet steel, foam
insulated. A positive fall to drain shall be provided with
3/4" B.S.P. female bottom
connection.
Filters
Filters shall
be washable EU3, continuous filament
media.
Please click here to copy the specification to your
clipboard ready to paste into your project
specification.
|
|
|
| |
|
|
|
![]() |
![]() |
![]() | |
|
